Uponor Smatrix Base PULSE User Manual

Digital thermostat T-148:
• Set the ECO setback value in menu 03 to 0 and menu 00 to Off.
Heating/cooling switch
The heating/cooling switch is manually controlled through the Uponor
Smatrix PULSE app (which controls the whole system), an external
signal, the supply temperature, or depending on the indoor/outdoor
temperature. It is used to switch the operation of the room controller
between heating and cooling modes.
A single external signal (if used) can be connected to up to four Base
room controllers at the same time, working in parallel. Reducing the
number of heating/cooling switches needed in the system.
4.4
Network connectivity
WWW
Wi-Fi
(Wi-Fi)
Wi-Fi
API
(Ethernet)
SD0000029
F
D
C
B
E
A
G
Note
Setting up a system with a communication module
requires a mobile device (smart phone/tablet).
Note
API connection only supports external control.
The room controller (C) can be setup and controlled using the Uponor
Smatrix PULSE app (A) and communication module (B) through
different connection methods.
Direct connection
The Uponor Smatrix PULSE app (A) communicates with the room
controller (C) via direct connection.
• The mobile device connects directly, using Wi-Fi, to the access
point in the communication module (B).
• The sub room controller (D) communicates via the master room
controller (C).
When is this method is used?
• When installing and setting up a system.
• During normal operation when there is no local Wi-Fi network
available.
Local Wi-Fi connection
The Uponor Smatrix PULSE app (A) communicates with the room
controller (C) via the local Wi-Fi network.
• The mobile device connects to the same Wi-Fi router (E) as the
communication module (B).
• The communication module (B) and Wi-Fi router (E) are
connected using either Wi-Fi or efternet.
• The sub room controller (D) communicates via the master room
controller (C).
When is this method is used?
• During normal operation when connected to the same local Wi-
Fi network.
Remote connection
The Uponor Smatrix PULSE app (A) communicates with the room
controller (C) via a remote connection.
• The mobile device connects toUponor cloud services (F) over
internet (via local Wi-Fi or mobile network).
• Uponor cloud services (F) connect to the communication module
(B) via the local internet connected Wi-Fi router (E).
• The communication module (B) and Wi-Fi router (E) are
connected using either Wi-Fi or efternet.
• The sub room controller (D) communicates via the master room
controller (C).
When is this method is used?
• During normal operation when outside the local Wi-Fi network.
• During normal operation when connected to the same local Wi-
Fi network.
18
|
Uponor Smatrix Base PULSE
|
Installation and operation manual

Uponor Smatrix Base PULSE Specifications

General

Brand	Uponor
Model	Smatrix Base PULSE
Category	Controller
Language	English