Uponor Smatrix Base PULSE User Manual

6 Install Uponor Smatrix Base room
thermostat
6.1
Uponor Smatrix Base T-141
Placement of thermostat
1.3–1.5 m
SD0000002
• Select an indoor wall and a position 1.3 m to 1.5 m above the
floor.
• Ensure that the thermostat is away from direct sunlight.
• Ensure that the thermostat will not be heated through the wall by
sunshine.
• Ensure that the thermostat is away from any source of heat, for
example television set, electronic equipment, fireplace,
spotlights, and so on.
• Ensure that the thermostat is away from any source of humidity
and water splashes (IP20).
Label thermostat
#01
#01
SI0000129
Label the thermostat, where suitable, with the channel numbers they
are to control, for example, #02, #03. For a system with several room
controllers, add the ID of each room controller, for example, 1.02,
1.03, 2.02, 2.03.
Connect communication cable to thermostat
+ -A B
1
2
SI0000032
1. Press the push buttons on the connection terminal on the back
of the thermostat.
2. While pressing the push buttons, insert each of the four wires
into the connection terminal on the thermostat (marked A,B, + or
-).
Attach thermostat to the wall
CD0000009
The thermostat is delivered in a kit with screws, wall plugs, and a wall
bracket, presenting several options of attaching the thermostat to the
wall.
36
|
Uponor Smatrix Base PULSE
|
Installation and operation manual

Uponor Smatrix Base PULSE Specifications

General

Brand	Uponor
Model	Smatrix Base PULSE
Category	Controller
Language	English