Uponor Smatrix Base PULSE User Manual

Room temperature sensor and floor temperature sensor
1. Room temperature (default)
2. Alarm list (only shown if an alarm is present)
3. Floor temperature, current ECO/Comfort mode, and current
heating/cooling demand
4. Relative humidity
Remote sensor
1. Remote sensor (default)
2. Alarm list (only shown if an alarm is present)
3. Remote sensor, current ECO/Comfort mode, and current
heating/cooling demand
4. Relative humidity
Room temperature sensor and outdoor temperature sensor
1. Room temperature (default)
2. Alarm list (only shown if an alarm is present)
3. Outdoor temperature, current ECO/Comfort mode, and current
heating/cooling demand
4. Relative humidity
Thermostat settings
Note
If no button on the thermostat is pressed for about
8 seconds, while in a submenu, the current values will be
saved and the software exits to the settings menu. About
about 60 seconds later, it exits to run mode.
In this menu all settings regarding the operation of the thermostat is
set.
Change settings
Uponor Smatrix Base T-146
To enter the settings menu:
1. Press and hold the OK button for about 3 seconds.
2. The settings icon and menu numbers is displayed in the top right
corner of the display.
3. Use buttons - or + to change the numbers to locate a submenu
(see list below).
02
Heating/cooling changeover
This menu is not visible if the thermostat is registered to a room
controller.
03
ECO mode setback temperature
04
Control mode
05
High floor temperature limitation
06
Low floor temperature limitation
07
Cooling allowed
08
Display unit
09
Climatic controller integration
11
Room temperature calibration
4. Press OK to enter parameter edit mode.
The parameter starts flashing.
5. Change parameters in the submenus.
6. Press and hold the OK button for about 3 seconds to exit the
settings menu.
76
|
Uponor Smatrix Base PULSE
|
Installation and operation manual

Uponor Smatrix Base PULSE Specifications

General

Brand	Uponor
Model	Smatrix Base PULSE
Category	Controller
Language	English