Utax 3005ci

10-35
Troubleshooting > Troubleshooting
1104 Failed to send the e-mail. Check the E-mail address.
NOTE
If the address is rejected by the domain, you cannot
send the E-mail.
page 5-37
Failed to send i-FAX. Check the i-FAX address.
NOTE
If the address is rejected by the domain, you cannot
send the E-mail.
Refer to FAX
Operation
Guide.
1105 Failed to send via SMB. Select [On] of the SMB settings on the Embedded
Web Server RX.
page 2-33
Failed to send the e-mail. Select [On] of the SMTP settings on the Embedded
Web Server RX.
page 2-33
Failed to send via FTP. Select [On] of the FTP settings on the Embedded
Web Server RX.
page 2-33
Failed to send i-FAX. Select [On] of the i-FAX settings on the Embedded
Web Server RX.
Refer to FAX
Operation
Guide.
1106 Failed to send the e-mail.
Failed to send i-FAX.
Check the sender address of SMTP on the Embedded
Web Server RX.
page 2-33
1131 Failed to send via FTP. Select [On] of the secure protocol settings on the
Embedded Web Server RX.
page 2-33
1132 Failed to send via FTP. Check the following of the FTP server.
• Is FTPS available?
• Is the encryption available?
page 2-33
2101 Failed to send via SMB. Check the network and SMB settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send via FTP. Check the network and FTP settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send the e-mail.
Failed to send i-FAX.
Check the network and Embedded Web Server RX.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• POP3 server name of the POP3 user
• SMTP server name
—
Error
Code
Message Corrective Actions
Reference
Page