4 Find the place of the jumper behind the fan.
5 If you change the EMC level, write "The EMC level
was changed" and the date on the "product
modified" label. If the label is not attached at this
time, attach it on the drive near the name plate.
Product modified
Date:
Date:
Date:
HOW TO FIND THE EMC JUMPERS 2 AND 3 (ONLY 200-500 V)
1 Remove the cover of the extension box, the touch
shield, and the I/O plate with the I/O grommet
plate.
2 Find the 2 EMC jumpers on the EMC board. They
are not adjacent to each other.
3 If you change the EMC level, write "The EMC level
was changed" and the date on the "product
modified" label. If the label is not attached at this
time, attach it on the drive near the name plate.
Product modified
Date:
Date:
Date:
7.7 MAINTENANCE
To make sure that the drive operates correctly and has a long life, we recommend that you
do regular maintenance. Refer to the table for maintenance intervals.
VACON · 116 COMMISSIONING AND ADDITIONAL INSTRUCTIONS
7
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
To Next Page
Loading...
