7 Put the cable entry plate with the cables into the
groove on the frame of the drive.
8 Connect the stripped cables.
a)
Expose the shield of all the 3 cables to make a
360-degree connection with the grounding
clamps for cable shield.
b)
Connect the phase conductors of the mains
cable and of the motor cable, and the
conductors of the the brake resistor cable into
the correct terminals.
c)
Attach the grounding conductor of each cable
to a grounding terminal with a grounding
clamp for grounding conductor.
d)
Make sure that the external grounding
conductor is connected to the grounding bar.
See chapter 2.4 Grounding and earth fault
protection.
e)
See the correct tightening torques in Table 23.
A. The grounding clamp for cable
shield
B. The terminals
C. The grounding terminal
D. The mains cable
E. The brake resistor cable
F. The motor cable
POWER CABLING VACON · 73
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
5
To Next Page
Loading...
