8 Cut the grommets open to move the cables through
them.
a)
Do not cut the grommet openings wider than
what is necessary for the cables that you use.
b)
If the grommets fold in when you put the cable,
pull the cable back to make the grommets
straight.
9 Attach the grommet and the cable so that the
frame of the drive goes into the groove of the
grommet.
a)
With the enclosure class IP54, the connection
between the grommet and the cable must be
tight. Pull the first bit of the cable out of the
grommet so that it stays straight.
b)
If this is not possible, make the connection
tight with some insulation tape or a cable tie.
POWER CABLING VACON · 83
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
5
To Next Page
Loading...
