2 In IP21, cut free the opening on the cover of the AC
drive for the Ethernet cable.
In IP54, cut a hole in a grommet and move the
cable through it.
a)
If the grommet folds in when you put the cable,
pull the cable back to make the grommet
straight.
b)
The hole in the grommet must not be wider
than your cable.
c)
Pull the first bit of the cable out of the
grommet so that it stays straight. If this is not
possible, make the connection tight with some
insulation tape or a cable tie.
IP21
IP54
CONTROL UNIT VACON · 97
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
6
To Next Page
Loading...
