50 • vacon description of parameters
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
7
403 Start signal 1
(2.2.5.1)
Signal selection 1 for the start/stop logic.
Default programming A.1.
404 Start signal 2
(2.2.5.2)
Signal selection 2 for the start/stop logic.
Default programming A.2.
405 External fault (close)
(2.2.5.11)
Contact closed: Fault is displayed and motor stopped.
406 External fault (open)
(2.2.5.12)
Contact open: Fault is displayed and motor stopped.
407 Run enable
(2.2.5.3)
Contact open: Start of motor disabled
Contact closed: Start of motor enabled
408 Acceleration/Deceleration time selection
(2.2.5.13)
Contact open: Acceleration/Deceleration time 1 selected
Contact closed: Acceleration/Deceleration time 2 selected
Set Acceleration/Deceleration times with parameters ID103 and ID104.
409 Control from I/O terminal
(2.2.7.18)
Contact closed: Force control place to I/O terminal
410 Control from keypad
(2.2.7.19)
Contact closed: Force control place to keypad
411 Control from fieldbus
(2.2.7.20)
Contact closed: Force control place to fieldbus
412 Reverse
(2.2.5.4)
Contact open: Direction forward
Contact closed: Direction reverse
413 Jogging speed
(2.2.5.16)
Contact closed: Jogging speed selected for frequency reference
See parameter ID124.
Default programming: A.4.
NOTE: When the control place is forced to change the values of Start/Stop, Direction
and Reference valid in the respective control place are used. The value of parameter
ID125 (Keypad Control Place) does not change. When the input opens the control
place is selected according to keypad control parameter ID125.
To Next Page
Loading...
Need help?
General
