Ceilometer CT25K
User’s Guide CT25K-U059en-2.1
32
1st (TOP)
LEVEL
2nd LEVEL 3rd LEVEL 4th LEVEL 5th LEVEL DESCRIPTION
GET VALUE TEMPERATURE BLOWER Print value of measured blower temperature, units: °C
CPU Print value of measured CPU board temperature, units: °C
LASER Print value of measured laser temperature, units: °C
LENS Print value of measured temperature adjacent to lens, units: °C
OUTSIDE Print value of measured outside temperature, units: °C
VOLTAGE BCIRCUIT Print status of battery circuit, connected / disconnected = 1/0
BATTERY Print value of battery voltage, approx. +13V
CHARGE Print value of battery charge voltage, approx. +13V
VCA Print value of internal raw voltage, approx. +25V
PHV Print value of Receiver high voltage, approx. +200V
PFB Print value of Receiver switcher internal feedback voltage, appr +2V
VALUE VOLTAGE P65 Print value of Transmitter high voltage, approx. +65V
P18 Print value of general internal supply voltage +18V
P13 Print value of Receiver supply voltage +13V
P12 Print value of general internal supply voltage +12.5V
P5G Print value of general internal supply voltage +5V
P5R Print value of Receiver supply voltage +5V
M13 Print value of Receiver supply voltage -13V
M12 Print value of general internal supply voltage -12.5V
M5R Print value of Receiver supply voltage -5V
M5G Print value of general internal supply voltage -5V
VERSION Print identifier for Software version
VLIM Print sky condition vertical visibility reporting limit (%)
START Start single-cycle measurement in operation mode STANDBY. Refer
to command SET OPER_MODE STANDBY.
STOP Stop internal compensation routine
To Next Page
Loading...
