Vaisala CT25K - 4.5 Polling Mode

Ceilometer CT25K
CT25K-U059en-2.1 User’s Guide
31
1st (TOP)
LEVEL
2nd LEVEL 3rd LEVEL 4th LEVEL 5th LEVEL DESCRIPTION
SET BAUD B300 Set data port serial line baud rate to 300
B1200 Set data port serial line baud rate to 1200
B2400 Set data port serial line baud rate to 2400
B4800 Set data port serial line baud rate to 4800
B9600 Set data port serial line baud rate to 9600
SW_STATUS OK Set report / algorithm conflict status bit ok
UNIT_ID 0...Z Unit Identifier: Alphanumerical character for message and polling
identification
GET ALGORITHM Print values of Algorithm parameters
DMC_SN Print DMC50 board serial number
DATA_ACQ Print settings of Data Acquisition
FACTORY Print values of Factory settings
INFO Print identifying information for this equipment configuration
MESSAGE Print Message Setting
OPER_MODE Print Operating Mode
OPTIONS Print installed modem and active options
PORT Print values of Port settings
STATUS Print STATUS message
SW_STATUS Print report / algorithm conflict status bit
UNIT_ID Print Unit Identification string
VALUE OTHERS ANGLE Print value of tilt angle sensor, range -15...+90 degrees from vertical
POWER_OF_P Print measured value of laser pulse power, units: mV at A-to-D
converter input
RECVALUE Print measured receiver test values
RADIANCE Print measured value of background radiance, units: mV at A-to-D
Converter input
WINDOW Print measured value of Window Contamination Monitor, units: mV
at A-to-D Converter input