Vaisala hmt120 - Table 8 Calcs Command

Syntax Description
Example:
?
Device Name : HMT120
SW Name : HMT120
SW model : HMT130
SW version : 0.9.3.389
Serial number : "F2220101"
Address : 0
Unit : METRIC
Ch1 Status : ON
Ch2 Status : ON
Probe name : "HMP110"
Probe SW : "1.01.1"
Probe SW date : ""
Probe SN : "F0740011"
Table 8 Calcs Command
Syntax Description
calcs [q1 q2]<cr>
where
q1,
q2
Any two of the allowed quantity
parameters, that is, RH, T, TD, TDF, A,
X, H, TW, PWS, PW
The calcs command shows the abbreviations of
the quantities measured by the transmitter. The
command can also be used to select the desired
quantities for measurement. Only after the
quantities have been set with the calcs
command, can these quantities be selected for
dierent outputs (see commands dsel, asel, and
form). The quantities in dsel, asel, rsel and form
must match with calcs.
Examples:
>calcs RH Td
>
calcs td t
>
Single-parameter transmitters HMT120H and HMT120T have only one quantity
(T for HMT120T, and RH, TD, TDF, A, X, H, TW, PWS, PW for HMT120H.)
HMT120 User Guide M211244EN-C
28