Vaisala hmt120 - Table 34 SAVE Command; Table 35 RESTORE Command

Syntax Description
Example (no active errors):
>errs
No errors.
>
Table 34 SAVE Command
Syntax Description
save<cr>
Use the save command to save changed
settings to the transmitter FLASH memory. Most
settings have to be saved or the changes are lost
at the next reset or power down.
The smode command saves the
new serial mode immediately,
and a separate save command is
not needed.
The probe calibration
commands (crh, ct, crhclr, ctclr)
store the parameters into the
probe's memory automatically
without a separate save
command.
Example:
>save
Saving settings...done
>
Table 35 RESTORE Command
Syntax Description
restore<cr>
Use the restore command to restore saved
settings from transmitter FLASH memory to
RAM. All unsaved changes will be lost.
>restore
Restoring default settings...done
>
Chapter 4 – Serial Line Operation
45