Vaisala hmt120 - Configuring Serial Line Operation; Table 23 SERI Command

Syntax Description
Example:
>acal
Ch1 I1 (mA) ? 5.60
Ch1 I2 (mA) ? 18.40
-1.40562890E+03 a0
1.41171900E+03 a1
OK
Ch2 I1 (mA) ? 5.60
Ch2 I2 (mA) ? 18.40
-1.40562890E+03 a0
1.41171900E+03 a1
OK
>
The question mark is displayed after a certain stabilization time has expired.
Only enter values after the question mark is displayed. Values entered before
the question mark are discarded.
4.9 Configuring Serial Line Operation
Table 23 SERI Command
Syntax Description
seri [b p d s]<cr>
where
b baud rate (9600, 19200, 38400, 76800,
115200)
p parity (n = none, e = even, o = odd)
d data bits (7 or 8)
s stop bits (1 or 2)
Use the seri command to show or set the serial
line settings for the serial port that you are
currently using. Use the SAVE command after
changing the settings to store them. The new
settings will be taken into use when the
transmitter is reset or powered up.
Chapter 4 – Serial Line Operation
37