Vaisala hmt120 - Table 24 ECHO Command; Table 25 SMODE Command

Syntax Description
Examples
>seri
Baud P D S : 19200 N 8 1
>
>seri 9600 e 7 1
Baud rate : 9600
Parity : E
Data bits : 7
Stop bits : 1
>save
Saving settings...done
>
Table 24 ECHO Command
Syntax Description
echo [on] [off]<cr>
To show or set the terminal echo status, use the
echo command.
Examples:
>echo
COM1 Echo : OFF
>
>echo on
COM1 Echo : ON
Table 25 SMODE Command
Syntax Description
smode [stop/run]<cr>
Use the smode command to show or set the
serial interface mode. Note that a separate save
command is not needed to store the new serial
interface mode setting.
STOP
mode
outputting only when command is
issued, any command can be used.
RUN
mode
outputting automatically, only
command S can be used.
HMT120 User Guide M211244EN-C
38