Vaisala hmt120 - Table 36 RESET Command; Table 37 FRESTORE Command; Table 38 UNIT Command

Table 36 RESET Command
Syntax Description
reset<cr>
Use the reset command to reset the transmitter.
Upon reset or power-up, the transmitter enters
the serial mode that has been set with the
smode command.
After a reset, the configuration is loaded from
FLASH memory. This configuration can be
altered by saving dierent settings with the
save command.
Example: Transmitter set to serial mode STOP, will output transmitter software version at reset
>reset
HMT120 / 0.1.0.001
Type "help" for command list
>
Table 37 FRESTORE Command
Syntax Description
frestore<cr>
Use the frestore command to restore the factory
settings to the transmitter. All user settings,
including the user-performed calibration
corrections, will be lost. The transmitter will
revert back to the factory calibrated settings.
Note that this only returns the factory settings
of the transmitter and not of the
interchangeable probe (see Table 19 (page 35)
and Table 21 (page 36)).
Example:
>frestore
Restoring factory defaults...done
>
Table 38 UNIT Command
Syntax Description
unit [metric/non_metric]<cr>
Use the unit command to show or set the output
unit (metric or non-metric).
HMT120 User Guide M211244EN-C
46