Replacing the Battery
Replacement Procedures
LigaSure Vessel Sealing Generator Service Manual 8-11
Replacing the Battery
The battery resides on the control board. Battery replacement involves removing
the cover, removing the control board, then removing the spent battery. Installing
the new battery involves reversing the process.
Figure 8 -6.
The location of the battery on the
control board
Tools Needed
• Phillips head screwdriver
Procedure
When you have removed the control board, if you need to replace the battery,
follow this procedure:
1. Grasp the battery and slide it up and out of the socket.
2. Position the new 3 V button cell battery above the socket so that the positive
side of the battery is facing out (visible).
3. Slide the battery down into the socket until it is firmly seated.
4. Reinstall the control board. For instructions, refer to Install the Control Board
in this chapter.
Battery
Important
Internal memory loses all data when you remove the battery. Therefore, after
replacing the battery, you must recalibrate the generator.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
