954
Model Code Page
61. Steering cylinder
1. 8. 1998
6000--8750 611 6
8. 11. 1990
13. Then fit a new o---ring and the rotor ring according to the
marks. Fit the rotor according to the figure above.
14. Fit the washer inside the rotor.
Note! See also the notes on the next column.
15. Fit the cover according to the marks and tighten the bolts
to a torque of 30---35 Nm.
16. Fit the steering valve (see next instruction).
Stepped
splines
Note! In the latest steering valves the rotor shaft and the rotor
have stepped splines at which time the mutual position of the
partsisdeterminedautomatically.
Note! The stepped splines also prevent the rotor shaft from
releasing from the cros s pin inside the valve. With regard to
possible repair works it is recommended,that aspacer isfitted
at the end of the rotor shaft to ensure the position of the shaft.
The spacers are still available as spare parts.
G. Fitting steering valve
1. Attach the bracket to the steering valve (17 mm) and secure
the screws with locking washers.
2. Place the valve into its place and guide t he steering wheel
column lower end into the valve splines.
3. Fasten the bracket to the cab front wall. Connect the oil
hoses according to the marks.
4. Test---run the tractor and check for leaks.
To Next Page
Loading...
