1265
Model
No Page
24.02.1999 6000---8750 99.6 1
PRESSURE FILTER INDICATION LIGHT, fitting instr.
(2)
The indication light indicates the blocked filter.
FITTING:
--- Clean the filter rear part. Remove the plug and
fit the indicator 1 an d o --- rin g 2 into the pressure
filter.
--- Connect the indicators to the w ire loom 3 ac-
cording to the picture (white wires to the earth
connection). Pass the wire loom under the cab
and bind it with plastic binders. Check that the
wires do not remain under moveable parts.
--- Connect the wire with a cable shoe under the
earth screw on the cab front wall (on the engine
side beside the brake pedal master cylinders).
The black wire is connected to pin 19 in connec-
tor on the cab front wall (37 pins).
--- Remove the combination instrument frame and
the instrument. Fit a lamp at the warning light
symbol. Reassemble the parts. Check the functi-
on by earthing the black wire.
--- If all filters do not have the indicator, the free
ends of the wires must be isolated and fasten on
thewireloom.
To Next Page
Loading...
