127
Model Code Page
37. Autocontrol 5
1. 10. 1999
370 9D
6250--8950
1. 9. 2002
VERSION 41
VERSIONS 42, 43, 50, 52, 60, 62
** TEST--- AND SETTING MODE **
In the service mode there are two modes:
--- test mode FII (for service man)
--- setting mode FIII (for srvice man)
In the service mode there are three modes:
--- test mode FII (for serviceman and driver)
--- setting mode FIII (for serviceman)
--- d r i v e r setting mode FIII > three settings (A: tyre dimension, F:
°C/°F, S: km/h / miles/h)
Setting of DPS initial pressures cannot be seen as a
pressure change in the setting mode. However, af-
fects the function of the DPS.
Setting of DPS initial pressures can be seen as a pressure change in
the setting mode.
Inthetestmodethetemperaturesensors(A1,A2)
show “L9” (= low), when the temperature is below
--- 9 °C.
Inthetestmodethetemperaturesensors(A1,A2)show“LO” (=
low), when the temperature is below ---9°C.
Counters are nor in use. 12 counters, which gather information, how many times and how
many minutes certain functions have been in use:
** FAULT CODES **
Fault code P101 causes fault code F321 => fault
function level 4 => tractor stops.
Program has been developed. Fault code P101 does not cause
other fault codes.
Fault code d225 appears, if the clutch pedal position is below 2%
(0---1%) and pedal limit switch S9 is not yet switched on.
VERSION 41
VERSIONS 42, 43, 50, 52, 60, 62
** INTERNAL FUNCTIONS**
When the PTO is started, pressure rises always ac-
cording to a certain curve (program).
When the PTO is started, pressure rises always according to a cer-
tain curve (program), but the PTO acceleration (sensor B7) is follo-
wed at certain intervals and when necessary pressure is raised.
Versions 50 and 60:
---Clutch pedal function precised
---Function of DPS automatic gear change (AutoDPS) has been ensu-
red when using reverse drive controls (TwinTrac)
Versions 52 and 62:
---Clutch pedal function precised
To Next Page
Loading...
