EasyManua.ls Logo

Valtra 6850 - Page 599

Valtra 6850
1361 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
550
Model
Code Page
4
Electric stop / control stop, fitting instruction
14.06.2001 (6)
8950Hi
39.11
6000---
11.01.1996
B) Control stop 33005600...................
33005610
This instruction concerns tractors with effect from
ser. no. 662343--> (ACII).
Note! The system requires the new starter
switch no. 32553200 ( as standard f rom March
--94) and the electric stop of the engine.
--- When a tractor drives an implement (e.g. com-
pressor, pump etc.) without driver’s control, the
control stop stops the engine when:
--- engine oil pressure lowers
--- gearbox oil pressure lowers
--- gearbox oil temperature rises
--- engine coolant temperature rises
(warning light comes on normally).
If the control stop is not needed, it can be
switched off with a ”Control Stop switch (S36) in
the instrument panel).
NOTE! The engine starts only when the Control
Stop is switched off with the switch.
B) F I T T I NG ( p a g e s 4 --- 6 ) :
--- Disconnect the battery earth wire. Open the
lever console side panel.
--- Find connector X29 in the rear part of the lever
console
Connect to this connector the corresponding
connector in wire loom 4.
--- On l y HiTech-- models with reverse drive con-
trols: Fitting as above mentioned, furthermore
connect the branched connector (X29, wire no 6
red) and connector wire no 15 (brown) to the
stop---warning light (see picture B1).
--- F i t t h e r e l a y h o ld er 7 onto the lever console
relay bracket (to the left side and down). Fasten
the holder with the same securing screw as the
opposite relay has been fastened. Fit the relay
9.
--- Pass the wire loom together with other wires
under the floor mat towards the instrument pan-
el.Refit the lever console side panel.
---Tractors with old model instrumentation to no
L17306 ( --L18104 HiTech): Fit the cable which
goes to the switch (S36) together with the cable
to the ignition switch with cable ties.
---Passthewireloom 4 to run up along the cab
front wall into the steering wheel console. Fasten
the wire loom with tape onto the other wires.

Table of Contents

Related product manuals