764
Model Code Page
441. Quick ---shift gear
6100--8400 441 4
15. 5. 1993
8. 11. 1990
6. Connect the rear flange joint of the propeller shaft ( 35 Nm)
(not Delta Powershift) and fit the guard plate.
Note! Tightening torque of the front axle attaching bolts is 380
Nm.
7. Lower the cab front end and tighten the cab fixing bolts to
200 Nm. Fit the plastic covers to the cab lower front edge on
both sides.
8. Connect the hoses to the steering valve according to the
marks. Fit the windscreen washer hose and cable connecto r.
9. Connect the cable to the starter motor. Connect the socket
and the accelerator pedal cable wire (on the RH side). Con-
nect the cab earth lead to the cab fro nt wall.
10. Fit the clutch lever/adjusting rod or cable according to the
measurements (---659477) or connect the release cable front
end through the access hole on the frame (659478---). Con-
nect the stop control to the injection pump. Connect the cab
heater hoses.
11. Remove the support plates on the front axle. Connect the
battery earth cable. Fill the transmission with oil.
12. Fit the engine hood plates and test---drive the tractor. Ad-
just the clutch and make sure that the throttle control and stop
control function properly. Check for leaks.
13. Make sure that the quick---shift gear functions properly.
Note! E---models: check that the sensor wires have been con-
nected and that the AC---III unit functions.
To Next Page
Loading...
