218
Model Code Page
45. Final drives
8350--8950Hi 450 8
1. 9. 2002
Picture 6. Final drives 700.
This final drive is fitted on 8350 ---8950Hi from chassis number L32106 incl.
--- Flange distance 1750 mm..............
This final drive is totally new (gear ratio has been
changed). The drive shaft diameter has been increased 10
mm.
Planet gears (2) are supported with taper roller beari ngs.
1. Cassette seal is 10 mm greater than in final gears 650.
Between wear ring and drive shaft ther e is an o---ring.
2. Planet gear
3. Adjusting drive shaft bearing pre---load:
Placethedriveshaftwiththewheelflangeonthefloor.Bed
in the bearings by rotating the axle housing 20---30 turn.
Tighten the centre screw to a torque of 10---20 Nm.Again
rotate the axle housing and check the torque.
Note! After some time of operation the correct bearing
clearancewillbeestablished.
Turn the lock washer for the centre screw so that the notch
on the washer locates in the recess in the planetary retainer.
Apply Loctite 2701 onto the threads of locking bolt.
4. Axle housing.
5. Oil draining plug.
Change of transmission oil and cleaning of suction strainer
at every 1000 running hours.
6. Apply sealing compound Hylosil RTV Grade A
(UK 0067).
7. Brake housing (left and right housings are different).
8. Support brake.
Brake pin has been removed (lugs on the intermediate
discs keep the brake parts in place).
9. Brake discs pack is new.
--- friction discs 9,5” (243 mm) x 7” (178 mm), 5 pcs.
--- intermediate discs (s= 5mm), 3 pcs.
10. Rotation speed sensor for rear axle.
To Next Page
Loading...
