2920 Float & Tape Transmitter 5 Display and Configuration Interface
98 Installation and Operations Manual
To Access HART Master:
1. Press Enter to access the Main Menu. The System Menu point is automatically highlighted.
2. Press Minus fourteen times to move the highlight to HART Master.
3. Press Enter and the HART Master menu opens.
4. To select one of the options, press Minus to move the highlight to the option you want and
then press Enter.
Refer to the table below for more information on each HART Master option.
Display Only Description
Addr The short address of current Slave Device.
Cmd The current command issued to slave device.
Request The current request message issued to slave device.
Reply The current reply message from Slave device.
HARTType Hart Bus Configuration, as follows:
• Active: 2920 provides power to HART bus
• Passive: HART bus is power by external supply
Num Inst. List The number of Slave devices currently being polled.
Num Requests The number of message requests sent out by the HART
master.
Num Responses The number of message responses from slave devices.
Pnt Status Byte value indicating status of point. Values are:
0: No error
Elapse Time of last update.
Pnt CheckSum CRC-16 Checksum of point's static configuration
parameters.
Display Only
Commands
Config Params
All Params
Main Menu
HART Master
Calibration
System Data
14
HART Master
To Next Page
Loading...