Varec 2920 - NMT Prothermo

5 Display and Configuration Interface
Varec, Inc. 89
NMT Prothermo
The NMT Prothermo menu contains parameters and allows configuration of the NMT
Prothermo software point ATS connected to the gauge.
NMT Prothermo menu presents 4 options:
• Display Only — data display, such as average temperature or vapor temperature
• Commands — commands that can be executed from the NMT Prothermo menu
• Config Params — parameters that are used to configure data in NMT Prothermo
• All Params — scrolls through the Display, Commands, and Config parameters in one
menu
To Access NMT Prothermo:
1. Press Enter to access the Main Menu. The System Menu point is automatically highlighted.
2. Press Minus eleven times to move the highlight to NMT Prothermo.
3. Press Enter and the NMT Prothermo menu opens.
4. To select one of the options, press Minus to move the highlight to the option you want and
then press Enter.
Refer to the table below for more information on each NMT Prothermo option.
All Params Lists all Display, Commands, and Config Params in a list.
Display Only
Commands
Config Params
All Params
Main Menu
NMT Prothermo
HART Device
FMR Radar
11

NMT Prothermo