Varec 2920 - Installation Overview

2920 Float & Tape Transmitter 2 Installation
12 Installation and Operations Manual
Installation Overview
To install the transmitter, follow the steps shown in the following flowchart:
Preparation
(Chapter 2)
Mounting
(Chapter3)
Wiring
(Chapter 4)
Initial Configuration
Bi-Phase Mark (BPM)
(Chapter 6)
Initial Configuration
MODBUS
(Chapter 7)
General Configuration &
Calibration
(Chapter 11)
Initial Configuration
Mark/Space
(Chapter 8)
Initial Configuration
L&J Tankway
(Chapter 9)