Vaz 21213 - Page 215

213
TRANSMISSION
Reversing light switch å14ı1.5 28.4-45.1 (2.9-4.6)
Clutch housing-to-engine bolts å12ı1.25 53.9-87.2 (5.5-8.9)
Clutch housing-to-transmission retaining nut å10ı1.25 31.8-51.4 (3.25-5.25)
Clutch housing-to-transmission retaining nut å8 15.7-25.5 (1.6-2.6)
Shift rod detent cover bolt å8 15.7-25.5 (1.6-2.6)
End cover retaining nut å8 15.7-25.5 (1.6-2.6)
Output shaft rear end nut å20ı1.0 66.6-82.3 (6.8-8.4)
Intermediate shaft bearing clamping washer bolt å12ı1.25 79.4-98 (8.1-10.0)
Fork-to-shift rod retaining bolt å6 11.7-18.6 (1.2-1.9)
TRANSFER BOX
Mounting bracket-to-rubber shaft retaining nut å10ı1.25 26.5-32.3 (2.7-3.3)
Mounting bracket-to-body retaining nut å8 15.0-18.6 (1.53-1.9)
Nut holding covers of transfer box casing, front axle drive casing,
speedometer drive unit housing, control lever bracket å8 14.7-24.5 (1.5-2.5)
Differential lockup switch å16ı1.5 28.4-45 (2.9-4.6)
Fork-to-selector rod retaining bolt å6 11.8-18.6 (1.2-1.9)
Fork-to-differential lockup rod retaining bolt å12ı1.25 11.7-18.6 (1.2-1.9)
Driven gear retaining bolt å10ı1.25 66.6-82.3 (6.8-8.4)
Retaining bolt, driving shaft rear bearing and intermediate shaft rear bearing å18ı1.5 96-117.6 (9.8-12.0)
Nut holding propeller shaft flange to driving shaft and
to front / rear axle driveshafts å16ı1.5 96-117.6 (9.8-12.0)
DRIVE LINE
Nut, bolts holding flexible coupling to gearbox and transfer box flanges å12ı1.25 57.8-71.5 (5.9-7.3)
Nut, bolt holding propeller shaft flange to flanges of
front/rear axles reduction gear and transfer case å8 27.4-34.3 (2.8-3.5)
FRONT AXLE
Front axle-to-engine retaining bolt å12ı1.25 74.5-92 (7.6-9.4)
Front axle-to-engine retaining nut å12 60.8-75 (6.2-7.66)
Front axle-to-engine retaining bolt å10ı1.25 42.1-52 (4.3-5.3)
Inner joint housing bearing cover retaining nut å8ı1.25 19.6-24.5 (2.0-2.5)
Differential bearing cover retaining nut å12ı1.25 62.7-75.4 (6.3-7.7)
Retaining bolt, lockplate-to-spring washer å6ı1 3.8-6.2 (0.39-0.63)
Driven gear securing bolt å10ı1.25 83.3-102.9 (8.5-10.5)
REAR AXLE
Bolt holding reduction gear casing to rear axle beam å8 35-43.2 (3.57-4.41)
Differential bearing cover bolt å10ı1.25 43.3-53,5 (4.42-5.46)
Driven gear bolt å10ı1.25 83.3-102.9 (8.5-10.5)
Flange-to-drive gear nut å16ı1.5 Refer to section «Rear axle»
Retaining nut, axleshaft bearing and rear brake å10ı1.25 41.6-51.4 (4.25-5.25)
FRONT SUSPENSION
Nut, lower bolts holding cross-member to chassis arms å12ı1.25 66.6-82.3 (6.8-8.4)
Nut, upper bolts holding cross-member to chassis arms å12ı1.25 66.6-82.3 (6.8-8.4)