Vaz 21213 - Page 216

214
Nut, bolt holding recoil block bracket to cross-member å8 15.1-18.6 (1.53-1.9)
Nut, upper control arm shaft bolt å12ı1.25 66.6-82.3 (6.8-8.4)
Shock-absorber upper end retaining nut å10ı1.25 27.4-34 (2.8-3.46)
Shock-absorber lower end retaining nut å10ı1.25 50-61.7 (5.1-6.3)
Nut, front wheel hub bearing å18ı1.5 Refer to «Running gear»
Brake caliper-to-steering knuckle retaining bolt å10ı1.25 29.1-36 (2.97-3.67)
Anti-roll bar retaining nut å8 15-18.6 (1.53-1.9)
Balljoint-to-steering knuckle retaining nut å14ı1.5 83.3-102.9 (8.5-10.5)
Radius rod-to-suspension crosspiece nut å12ı1.25 66,6-82,3 (6.8-8.4)
Radius rod-to-body retaining nut å16ı1.5 104.9-169.5 (10.7-17.3)
Lower arm shaft-to-crosspiece connecting nut å16ı1.5 114.7-185.2 (11.7-18.9)
Balljoint-to-suspension arm retaining nut å8 20.6-25.75 (2.1-2.63)
Nut, wheel retaining bolt å12ı1.25 62.4-77.1 (6.37-7.87)
Suspension upper arm shaft nut å14ı1.5 63.7-102.9 (6.5-10.5)
Nut, swing arm retaining bolt å12ı1.25 66.6-82.3 (6.8-8.4)
REAR SUSPENSION
Shock-absorber retaining nut å12ı1.25 38.2-61.7 (3.9-6.3)
Nut, Panhard rod and trailing arms retaining bolts å12ı1.25 66.6-82.3 (6.8-8.4)
STEERING
Nut, steering box retaining bolt å10ı1.25 33.3-41.2 (3.4-4.2)
Nut, idler arm bracket retaining bolt å10ı1.25 33.3-41.2 (3.4-4.2)
Nut, steering rod ballpin ** å14ı1.5 42.1-53 (4.3-5.4)
Middle shaft-to-upper shaft and worm shaft retaining nut å8 22.5-27.4 (2.3-2.8)
Steering wheel retaining nut å16ı1.5 31.4-51 (3.2-5.2)
Steering shaft bracket and ignition switch retaining nut å8 15-18.6 (1.53-1.9)
Drop arm nut å20ı1.5 199.9-247 (20.4-25.2)
Idler arm shaft nut å14ı1.5 63.7-102.9 (6.5-10.5)
_______________________________________________________________________________________________________________
* It is allowed to round tightening torques for nuts and bolts to the tenth of kgf•m within the tolerance.
** With the nut recess mismatching the cotter pin hole, tighten to further torque (less than 60°) to ensure a reliable locking