Vermes MDS 3200A - Page 49

VTK‐VS‐BA‐004e‐B|UserManualMDS3200A | Communication Interfaces
49
33. TAPPET:SET:<value>
 Description: Bythiscommand,theusercandecideonthenumberofcyclestobeper‐
formeduntilthenextmaintenanceofthetappet.Aftermaintenance,reset
counterbycommandno.32describedabove.
Ifnoselectionismade,thevalueremains“infinite”.
 Example: 
 Input: TAPPET:SET:500000
 Result: 500000cycleshavebeenselected.
 Return: OK

34. NOZZLE:SET::<value>
 Description: Thiscommanddeterminesthenumberofcyclestobeperformeduntilthe
nextmaintenanceofthenozzleinsert.Aftermaintenance,resetcounterby
commandno.35describedbelow.
 Example: 
  Input: NOZZLE:SET:500000
  Result: 500000cycleshavebeenselected.
  Return: OK

35. NOZZLE:CLEAR
 Description: Thecontentofthenozzlemaintenancecounteriserased.
 Example: 
 Input: NOZZLE:CLEAR
 Result: Counterresetto“0“.
 Return: OK

36. SYSTEM:SHOW:AKTORTEMP
 Description: Thecurrenttemperatureoftheactuator(piezo)isdisplayed.
 Example: 
  Input: SYSTEM:SHOW:AKTORTEMP
  Result: Thevalueappearsin°C.
  Return:80

37. HELP
 Description: ShowalistwithallRS‐232Cinstructions.
 Example: 
  Input: HELP
  Result: ListwithRS‐232Cinstructions.
  Return: Listwithinstructions.
