SNMPv3 Authentication Secret
Pass phrase or password used for SNMPv3 Get request. This string can be composed of printable characters with the
exception of colon, tab, double quote, and question mark. The entry must be from eight to 64 characters.
SNMPv3 Privacy
Cryptographic algorithm used for encryption. Options are:
• None
• DES
• AES
SNMPv3 Privacy Secret
Pass phrase or password used for SNMPv3 Get request. This string can be composed of printable characters with the
exception of colon, tab, double quote, and question mark. The entry must be from eight to 64 characters.
SNMPv3 Trap Target Addresses
Network hosts that will receive SNMPv3 traps, identified with either a network name or IP address. Multiple addresses
must be separated by commas.
SNMPv3 Trap Port
Port used by the target host for receiving SNMPv3 traps; default is 162.
Configuring SNMPv1 Traps
You may configure up to 20 network hosts that receive SNMPv1 traps. The top level is a list of all 20.
1. Touch , then > BMS & Teamwork > IS-Unity
Setup > Protocols > SNMP> SNMPv1 Traps, then one of
the listed traps.
2. Enter the information and set the permissions appropriate to the host/trap, and touch Save.
3. Repeat steps 1 and 2 for additional traps.
4. Restart Unity:
a. Touch , then > BMS & Teamwork > IS-Unity
Settings.
b. Touch Restart IS-Unity., then touch Yes.
SNMPv1 Trap Settings
SNMP Trap Target Addresses
Configure network hosts that will receive alert notifications (SNMP Traps). The host can be identified as either an IP
address or the host’s network name.
8 External Monitoring andBuilding ManagementSystems
149
Vertiv™ Liebert® iCOM™Installer/User Guide
To Next Page
Loading...
