Vertiv Liebert iCOM - Page 92

Enable
Enables/disables notification. Touch the switch to set On or Off.
• When disabled, events are not logged or displayed and visual/audible alarm notifications are not made.
Type
Logging and notification level of the event. Table 4.1 below , describes the event type and notification it generates.
Table 4.2 on page87 , lists the default types for events.
Type Description
Message Stored in event log only. No visual or audible notification.
Warning
Listed with a yellow status dot on the ALARMS panel and the LED flashes.
See Table 11.1 on page165 , and Viewing Unit Alarms on page17 .
Alarm
Listed with a red status dot on the ALARMS panel, the LED flashes, and the audible alarm sounds.
See Table 11.1 on page165 , Viewing Unit Alarms on page17 , and Enabling the Audible Alarm Notification on page92 .
Table 4.1 Notification Types
Table 4.2 on page87 , lists the default settings for each event.
• Internal delay is factory set and not adjustable. It is the time delay after event trigger that notification is sent.
• Default delay may or may not be adjustable and is added to the internal delay of event notification.
• Type may be adjustable or may be fixed.
4 Managing Events: Alarms,WarningsandMessages
84
Vertiv™ Liebert® iCOM™Installer/User Guide