77
Tab 5S UP - 40515
IT
Add
Click on the programming preview for a day to open a panel for adding and managing time bands, in this case where
not yet created.
The navigation bar at the bottom of the screen shows the selected day in yellow. Click on another day, without returning
to the previous screen, to change it. The changes made to this page are stored implicitly.
The help texts shown in grey on the left side of the screen are dynamic and so change according to the contents
displayed.
Click on “Add” to view a pop-up to select the start and end time in tumbler mode; the band start time is set with the
current value and the end time with the current value + 1 hour.
Scroll the values to set the interval. The system automatically requires the start time to be before the end time.
If an incorrect activation time is entered, an error message is displayed.
The user is asked to set an end time later than the indicated start time.
Select “Exit” to return to the screen before the time settings.
To Next Page
Loading...
Need help?
General
