Vivotek ND8401 - Video Settings and Enhancements; Snapshot Settings

VIVOTEK
124 - User's Manual
How to Congure Client Settings
In Client Settings, you can configure Snapshot Settings, Recording Settings, View Settings,
General Settings, Joystick Settings, Proxy Settings, and PiP Settings.
Snapshot Settings
Please follow the steps below to congure snapshot settings:
a. Click Conguration > Client Settings > Snapshot Settings on the menu bar to open the Snapshot
Settings window.
b. Select a picture format for snapshots (BMP or JPEG). If you select JPEG format, you can adjust the
recompression quality (from 1 to 100). Note that a higher value would generate higher picture quality
but lower compression rate.
c. Fill in a lename prex for the snapshots.
d. The default storage path for snapshots is E:\UserData\Snapshot. You can not change target directory.
e. If you check Generate a le name automatically, NVR will directly save snapshots with the following
lename format to the storage folder.
b
c
Snapshot_20100125_173015_01.jpg
File name prex Date and time
(YYYYMMDD_hhmmss)
Serial number of snapshots
Picture format
e
The recompression quality is only
enabled in H.264 streaming. If your
stream source is MJPEG, the system will
directly save the JPEG image without
recompression.
NOTE: