VEHICLE INFORMATION
1. Power the motorcycle off. Disconnect the battery.
2. Sitting on the vehicle, use a 6mm Allen head, to loosen bolts at
handlebar clamps.
3. Move the handlebar back and forth until a comfortable position is
obtained.
4. When position is obtained, re-tighten the bolts at the handlebar
clamps.
WARNING Be sure the bolts are fastened completely.
Throttle
Twist the right handgrip to operate the throttle [Fig.1]. This controls the
vehicle’s acceleration/power.
To accelerate, roll the throttle backward (towards you ).
To decelerate, roll the throttle forward (away from you).
The throttle should spring back completely to the idle position when you
release the grip. This will cause the vehicle to decelerate, and slow down. To
fully stop, the use of brakes is required.
WARNING Ensure the motorcycle power switch is OFF before getting
on or getting off of the motorcycle. You can inadvertently twist the grip of the
motorcycle during load, unload, simple move or turn of the handlebar.
Unexpected acceleration due to inadvertently twisting the throttle while the
motorcycle is on will result in sudden movement which can cause injury or
damage to the operator, bystanders or property around you.
960-101086 Rev B Page 17 of 69
To Next Page
Loading...