VEHICLE INFORMATION
WARNING Reading or tampering with the display can distract you from
the operation of the vehicle. Always pay attention to the trail conditions, and
ensure your environment is clear and free from obstacles. When riding, only
glance at the display briefly to maintain awareness of trail conditions.
The display provides three views: Speedometer, Ride Mode, and Battery
status.
You can cycle through the view by rotating the circular ring around the
display.
- SPEEDOMETER: will show the speed you are traveling with the mode
shown just below the numeric speed value
- RIDE MODE: will show which mode you are functioning
- BATTERY STATUS: will show you the life of the battery in a bar value
and percentage. The screen also displays voltage, amperage, and
mode.
ALERTS - If an issue is detected during your ride, an alert message will appear
on the display screen. The alert will remain for 5 seconds. If you are in a safe
position to review, you can simply turn the dial to navigate to the alert
screen. Then tap the alert screen to see the specific alert(s). If there is more
than one, you can rotate the dial to scroll through the alert(s).
NOTE: The alert(s) will not remain in memory after 5 seconds. The display
will not retain memory of alert(s) if the motorcycle is powered off. Alert(s)
will appear in the Volcon app, if you have an active account and are
connected to the EVO at time of alert(s). Please contact service@volcon.com
should you encounter any alert(s) that are recurring or do not clear when
motorcycle power is cycled off and on.
960-101086 Rev B Page 21 of 69
To Next Page