VOLTCRAFT FG-1602 - [Source[1|2]]:Am:state; [Source[1|2]]:Askey[:Amplitude]

13
Returns
INT|EXT
Examples
SOURce1:AM:SOURce INTernal
sets the CH1 source of modulating signal to internal.
[SOURce[1|2]]:AM:STATe
This command enables or disables AM modulation for the specified channel. The query
returns the state of AM modulation.
Syntax
[SOURce[1|2]]:AM:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:AM:STATe?
Arguments
If [SOURce[1|2]] are omitted, CH1 is specified automatically.
ON or <NR1>≠0 enables AM modulation.
OFF or <NR1>=0 disables AM modulation.
Returns
<NR1>
Examples
SOURce1:AM:STATe ON
enables the CH1 AM modulation.
[SOURce[1|2]]:ASKey[:AMPLitude]
This command sets or queries the modulation amplitude of ASK modulation for the
specified channel. Set the modulation amplitude from 0 Vpp to the current amplitude of
the carrier waveform. The amplitude resolution is 1 mVpp or four digits.
Syntax
[SOURce[1|2]]:ASKey[:AMPLitude] {<amplitude>|MINimum|MAXimum}
[SOURce[1|2]]:ASKey[:AMPLitude]? [MINimum|MAXimum]
Arguments