VOLTCRAFT FG-1602 - [Source[1|2]]:Askey:internal:rate; [Source[1|2]]:Askey:source

14
<amplitude>::=<NRf>[<units>]
where:
<NRf> is the modulation amplitude.
<units>::=[mVpp|Vpp]
MINimum sets the modulation amplitude to minimum value.
MAXimum sets the modulation amplitude to maximum value.
Returns
<amplitude>
Examples
SOURce1:ASKey:AMPLitude MAXimum
sets the amplitude of modulating signal on CH1 to the maximum value.
[SOURce[1|2]]:ASKey:INTernal:RATE
This command sets or queries the internal modulation rate of ASK modulation for the
specified channel. Use this command when the internal modulation source is selected.
Syntax
[SOURce[1|2]]:ASKey:INTernal:RATE {<rate>|MINimum|MAXimum}
[SOURce[1|2]]:ASKey:INTernal:RATE? {MINimum|MAXimum}
Arguments
<rate>::=<NRf>[<units>]
where:
<NRf> is the modulation rate.
<units>::=[Hz|kHz|MHz]
Returns
<rate>
Examples
SOURce1:ASKey:INTernal:RATE 50Hz
sets the CH1 internal modulation rate to 50 Hz.
[SOURce[1|2]]:ASKey:SOURce
This command sets or queries the source of modulation signal of ASK modulation for the
specified channel.