VOLTCRAFT FG-1602 - [Source[1|2]]:Fskey:internal:rate; [Source[1|2]]:Fskey:source

27
[SOURce[1|2]]:FSKey:INTernal:RATE
This command sets or queries the internal modulation rate of FSK modulation for the
specified channel. Use this command when the internal modulation source is selected.
Syntax
[SOURce[1|2]]:FSKey:INTernal:RATE {<rate>|MINimum|MAXimum}
[SOURce[1|2]]:FSKey:INTernal:RATE? {MINimum|MAXimum}
Arguments
<rate>::=<NRf>[<units>]
where:
<NRf> is the modulation rate.
<units>::=[Hz|kHz|MHz]
Returns
<rate>
Examples
SOURce1:FSKey:INTernal:RATE 50Hz
sets the CH1 internal FSK modulation rate to 50 Hz.
[SOURce[1|2]]:FSKey:SOURce
This command sets or queries the source of modulation signal of FSK modulation for the
specified channel.
Syntax
[SOURce[1|2]]:FSKey:SOURce [INTernal|EXTernal]
[SOURce[1|2]]:FSKey:SOURce?
Arguments
INTernal means that the carrier waveform is modulated with an internal source.
EXTernal means that the carrier waveform is modulated with an external source.
Returns
INT|EXT
Examples
SOURce1:FSKey:SOURce INTernal
sets the CH1 source of modulating signal to internal.