VOLTCRAFT FG-1602 - [Source[1|2]]:Oskey:time; [Source[1|2]]:Phase[:Adjust]

34
SOURce1:OSKey:STATe ON
enables the CH1 OSK modulation.
[SOURce[1|2]]:OSKey:TIME
This command sets or queries the oscillate period for the OSK modulation for the
specified channel.
Syntax
[SOURce[1|2]]:OSKey:TIME {<seconds>|MINimum|MAXimum}
[SOURce[1|2]]:OSKey:TIME?
Arguments
<seconds>::=<NRf>[<units>]
where:
<NRf> is the oscillate period in seconds.
<units>::=[ns|us|ms|s]
Returns
<seconds>
Examples
SOURce1:OSKey:TIME 100us
sets the CH1 OSK oscillate period to 100 us.
[SOURce[1|2]]:PHASe[:ADJust]
This command sets or queries the phase of output waveform for the specified channel.
Set the value in radians or degrees. If no units are specified, the default is RAD. The query
returns the value in RAD.
This command is supported when you select a waveform other than DC and Noise.
Syntax
[SOURce[1|2]]:PHASe[:ADJust] {<phase>|MINimum|MAXimum}
[SOURce[1|2]]:PHASe[:ADJust]? {MINimum|MAXimum}
Arguments
<phase>::=<NR3>[<units>]
where:
<NR3> is the phase of output waveform.