VOLTCRAFT FG-1602 - [Source[1|2]]:Frequency:start; [Source[1|2]]:Frequency:stop

25
where:
<NRf> is the frequency span.
<units>::=[Hz|kHz|MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:SPAN 900 kHz
sets the CH1 frequency span to 900 kHz.
[SOURce[1|2]]:FREQuency:STARt
This command sets or queries the start frequency of sweep for the specified channel. This
command is always used with the [SOURce[1|2]]:FREQuency:STOP command. The
setting range of start frequency depends on the waveform selected for sweep.
Syntax
[SOURce[1|2]]:FREQuency:STARt {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:STARt? {MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]
where:
<NRf> is the start frequency.
<units>::=[Hz|kHz|MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:STARt 10kHz
sets the sweep start frequency of CH1 to 10 kHz.
[SOURce[1|2]]:FREQuency:STOP
This command sets or queries the stop frequency of sweep for the specified channel. This
command is always used with the [SOURce[1|2]]:FREQuency:STARt command. The
setting range of stop frequency depends on the waveform selected for sweep.