VOLTCRAFT FG-1602 - System:beeper[:Immediate] (no Query Form); System:beeper:state

47
{<amplitude>|MINimum|MAXimum}
[SOURce[1|2]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]? {MINimum|MAXimum}
Arguments
<amplitude>::=<NR3>[<units>]
where:
<NR3> is the output amplitude.
<units>::=[mVpp|Vpp]
Returns
<amplitude>
Examples
SOURce1:VOLTage:LEVel:IMMediate:AMPLitude 1Vpp
sets the CH1 output amplitude to 1 Vpp.
SYSTem:BEEPer[:IMMediate] (No Query Form)
This command causes the instrument to beep immediately. This command is only
available when the beeper is enabled.
Syntax
SYSTem:BEEPer[:IMMediate]
Arguments
None
Examples
SYSTEM:BEEPER
causes a beep.
SYSTem:BEEPer:STATe
The SYSTem:BEEPer:STATe command sets the beeper ON or OFF.
The SYSTem:BEEPer:STATe? command returns “0” (OFF) or “1” (ON).
When the beeper is set to ON, the instrument will beep when an error message or a
warning message is displayed on the screen. The instrument does not beep when an
error or warning caused by remote command execution.