VOLTCRAFT FG-1602 - [Source[1|2]]:Fm[:Deviation]; [Source[1|2]]:Fm:internal:frequency

21
[SOURce[1|2]]:BURSt:STATe?
Arguments
ON or <NR1>≠0 enables the burst mode.
OFF or <NR1>=0 disables the burst mode.
Returns
<NR1>
Examples
SOURce1:BURSt:STATe ON
enables the burst mode for the CH1.
[SOURce[1|2]]:FM[:DEViation]
This command sets or queries the peak frequency deviation of FM modulation for the
specified channel. The setting range of frequency deviation depends on the waveform
selected as the carrier.
Syntax
[SOURce[1|2]]:FM[:DEViation] {<deviation>|MINimum|MAXimum}
[SOURce[1|2]]:FM[:DEViation]? [MINimum|MAXimum]
Arguments
<deviation>::=<NRf>[<units>]
where:
<NRf> is the frequency deviation.
<units>::=[Hz|kHz|MHz]
Returns
<deviation>
Examples
SOURce1:FM:DEViation 1.0MHz
sets the CH1 frequency deviation to 1.0 MHz.
[SOURce[1|2]]:FM:INTernal:FREQuency
This command sets or queries the internal modulation frequency of FM modulation for the