VOLTCRAFT FG-1602 - [Source[1|2]]:Frequency[:Fixed]; [Source[1|2]]:Frequency:span

24
sets the CH1 center frequency to 550 kHz.
[SOURce[1|2]]:FREQuency[:FIXed]
This command sets or queries the frequency of output waveform for the specified channel.
The setting range of output frequency depends on the type of output waveform. If you
change the type of output waveform, it might change the output frequency because
changing waveform types impacts on the setting range of output frequency. The resolution
is 1 μHz or 12 digits.
Syntax
[SOURce[1|2]]:FREQuency[:FIXed] {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency[:FIXed]? {MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]
where:
<NRf> is the output frequency.
<units>::=[Hz|kHz|MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:FIXed 500kHz
sets the CH1 output frequency to 500 kHz.
[SOURce[1|2]]:FREQuency:SPAN
This command sets or queries the span of frequency sweep for the specified channel.
This command is always used with the [SOURce[1|2]]:FREQuency:CENTer command.
The setting range of frequency span depends on the waveform selected for sweep.
Syntax
[SOURce[1|2]]:FREQuency:SPAN {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:SPAN? {MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]