VOLTCRAFT FG-1602 - [Source[1|2]]:Pm:state; [Source[1|2]]:Pskey[:Deviation]

37
Examples
SOURce1:PM:SOURce INTernal
sets the CH1 source of modulating signal to internal.
[SOURce[1|2]]:PM:STATe
This command enables or disables PM modulation. The query returns the state of PM
modulation. Select a sine, square, ramp, or arbitrary waveform as the carrier waveform.
Syntax
[SOURce[1|2]]:PM:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:PM:STATe?
Arguments
ON or <NR1>≠0 enables PM modulation.
OFF or <NR1>=0 disables PM modulation.
Returns
<NR1>
Examples
SOURce1:PM:STATe ON
enables the CH1 PM modulation.
[SOURce[1|2]]:PSKey[:DEViation]
This command sets or queries the phase deviation of PSK modulation for the specified
channel.
Syntax
[SOURce[1|2]]:PSKey[:DEViation] {<deviation>|MINimum|MAXimum}
[SOURce[1|2]]:PSKey[:DEViation]? [MINimum|MAXimum]
Arguments
<deviation>::=<NR3>[<units>]
where:
<NR3> is the phase deviation.
<units>::=[RAD|DEG]
If <units> are omitted, RAD is specified automatically. The setting ranges are:
RAD: 0 PI to +1 PI, relative to phase value