36
[SOURce[1|2]]:PM:INTernal:FREQuency
This command sets or queries the internal modulation frequency of PM modulation for the
specified channel. Use this command when the internal modulation source is selected.
Set the internal modulation frequency from 2 mHz to 100.00 kHz with resolution of 1 mHz.
Syntax
[SOURce[1|2]]:PM:INTernal:FREQuency {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:PM:INTernal:FREQuency? [MINimum|MAXimum]
Arguments
<frequency>::=<NRf>[<units>]
where:
<NRf> is the modulation frequency.
<units>::=[Hz|kHz|MHz]
Returns
<frequency>
Examples
SOURce1:PM:INTernal:FREQuency 10kHz
sets the CH1 internal modulation frequency to 10 kHz.
[SOURce[1|2]]:PM:SOURce
This command sets or queries the source of modulation signal of PM modulation for the
specified channel.
Syntax
[SOURce[1|2]]:PM:SOURce [INTernal|EXTernal]
[SOURce[1|2]]:PM:SOURce?
Arguments
INTernal means that the carrier waveform is modulated with an internal source.
EXTernal means that the carrier waveform is modulated with an external source.
Returns
INT|EXT
To Next Page
Loading...