VOLTCRAFT FG-1602 - [Source[1|2]]:Sweep:state; [Source[1|2]]:Sweep:time

45
LOGarithmic sets the sweep spacing to logarithmic.
Returns
LIN|LOG
Examples
SOURce1:SWEep:SPACing LINear
sets the CH1 sweep spacing to linear.
[SOURce[1|2]]:SWEep:STATe
This command enables or disables the sweep mode for the specified channel. The query
returns the state of sweep mode.
Syntax
[SOURce[1|2]]:SWEep:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:SWEep:STATe?
Arguments
ON or <NR1>≠0 enables the sweep mode.
OFF or <NR1>=0 disables the sweep mode.
Returns
<NR1>
Examples
SOURce1:SWEep:STATe ON
enables the sweep mode for the CH1.
[SOURce[1|2]]:SWEep:TIME
This command sets or queries the sweep time for the sweep for the specified channel.
The sweep time does not include hold time and return time. The setting range is 1 ms to
500 s.
Syntax
[SOURce[1|2]]:SWEep:TIME {<seconds>|MINimum|MAXimum}
[SOURce[1|2]]:SWEep:TIME?
Arguments