VOLTCRAFT FG-1602 - [Source[1|2]]:Fskey:state; [Source[1|2]]:3 Fskey[:Frequency]

28
[SOURce[1|2]]:FSKey:STATe
This command enables or disables FSK modulation. The query returns the state of FSK
modulation. Select a sine, square, ramp, or arbitrary waveform as the carrier waveform.
Syntax
[SOURce[1|2]]:FSKey:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:FSKey:STATe?
Arguments
ON or <NR1>≠0 enables FSK modulation.
OFF or <NR1>=0 disables FSK modulation.
Returns
<NR1>
Examples
SOURce1:FSKey:STATe ON
enables the CH1 FSK modulation.
[SOURce[1|2]]:3FSKey[:FREQuency]
This command sets or queries the hop frequency of 3FSK modulation for the specified
channel.
Syntax
[SOURce[1|2]]:3FSKey[:FREQuency] <n>,{<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:3FSKey[:FREQuency]? <n>,{MINimum|MAXimum}
Arguments
<n>::=<NR1>
where:
<NR1> is the sequence number of hop frequency, which can be 1 or 2.
<frequency>::=<NRf>[<units>]
where:
<NRf> is the hop frequency.
<units>::=[Hz|kHz|MHz]