VOLTCRAFT FG-1602 - [Source[1|2]]:Oskey:internal:rate; [Source[1|2]]:Oskey:state

33
[SOURce[1|2]]:OSKey:INTernal:RATE
This command sets or queries the internal modulation rate of OSK modulation for the
specified channel.
Syntax
[SOURce[1|2]]:OSKey:INTernal:RATE {<rate>|MINimum|MAXimum}
[SOURce[1|2]]:OSKey:INTernal:RATE? {MINimum|MAXimum}
Arguments
<rate>::=<NRf>[<units>]
where:
<NRf> is the modulation rate.
<units>::=[Hz|kHz|MHz]
Returns
<rate>
Examples
SOURce1:OSKey:INTernal:RATE 50Hz
sets the CH1 internal OSK modulation rate to 50 Hz.
[SOURce[1|2]]:OSKey:STATe
This command enables or disables OSK modulation. The query returns the state of OSK
modulation. The carrier waveform can only be a sine wave.
Syntax
[SOURce[1|2]]:OSKey:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:OSKey:STATe?
Arguments
ON or <NR1>≠0 enables OSK modulation.
OFF or <NR1>=0 disables OSK modulation.
Returns
<NR1>
Examples