VOLTCRAFT FG-1602 - [Source[1|2]]:Bpskey:phase; [Source[1|2]]:Bpskey:state

17
[SOURce[1|2]]:BPSKey:PHASe
This command sets or queries the phase deviation of BPSK modulation for the specified
channel.
Syntax
[SOURce[1|2]]:BPSKey:PHASe {<phase>|MINimum|MAXimum}
[SOURce[1|2]]:BPSKey:PHASe? [MINimum|MAXimum]
Arguments
<phase>::=<NR3>[<units>]
where:
<NR3> is the phase deviation.
<units>::=[RAD|DEG]
If <units> are omitted, RAD is specified automatically. The setting ranges are:
RAD: 0 PI to +1 PI, relative to phase value
DEG: 0 to +180, in 1 degree steps, relative to phase value
Returns
<phase>
Examples
SOURce1:BPSKey:PHASe MAXimum
sets the maximum value for the CH1 phase deviation of BPSK modulation.
[SOURce[1|2]]:BPSKey:STATe
This command enables or disables BPSK modulation. The query returns the state of
BPSK modulation. Select a sine, square, ramp, or arbitrary waveform as the carrier
waveform.
Syntax
[SOURce[1|2]]:BPSKey:STATe {ON|OFF|<NR1>}
[SOURce[1|2]]:BPSKey:STATe?
Arguments
ON or <NR1>≠0 enables BPSK modulation.
OFF or <NR1>=0 disables BPSK modulation.
Returns
<NR1>