5-46 OM ET18/20/24 us 1.3 * et18_20_24b510.fm
5
General notices regarding work operation
Travel operation
Traveling over obstacles (rocks, tree stumps etc.) can put a heavy load on
the travel gear and cause damage. Avoid traveling over obstacles if
possible.
If it cannot be avoided, lower the boom to ground level and travel over the
obstacle at low speed at the middle of the running gear.
Travel operation in high speed
Travel slowly on rough terrain and avoid starting machine travel and
stopping abruptly as well as changing direction suddenly.
The stabilizer blade must be at the front when traveling in high speed.
Operation in water
Do not immerse the rear end of the machine in water. Bear this in mind in
particular when leaving water, in order not to damage the machine.
Water must not reach any farther than the upper edge of the tensioning
wheel.
Lubricate lubrication points again that were immersed in water for a longer
time in order to expel the old grease.
Never immerse the live ring or the upper carriage in water.
Fig. 198: Travel operation
Fig. 199: Traveling out of water
Fig. 200: Traveling in water
To Next Page
Loading...
